STIROMOL Bazni Styrofoam Adhesive
LED Vintage Bulb M1
LED 20W Track Light
LED Vintage Bulb 2000K 3W E27
LED Vintage Mini Bulb 2700K 4W E27
Multi-purpose Silicone Tape
Silicone Flexible 16x16mm Channel for LED Strip
LED Vintage Transparent Bulb 2700K 4W
LED Wall Light M1
LED Night Light (1W) with Automatic Light Sensor
Rail 3Mtr for LED Strip 20x10MM R1
Stainless Steel Toilet Set for Bidet
Maxima
ETA Certified
For outdoor and indoor use
STIROMOL Thermo is a one-component, elastic, dry-type construction adhesive, made from hydraulic and synthetic binding agents with added additives. It is intended for gluing styrofoam onto all types of mineral surfaces, as well as for the reinforcing layer of EPS boards.
STIROMOL Thermo, 25kg, is mixed with 6-6.5l of water and stirred until a homogeneous, lump-free mass is formed. Wait 10 minutes, then mix intensively again. The mass prepared in this way is ready for use and must be used within 2 hours. STIROMOL Thermo is applied to the thermal insulation boards along the edges and at 3-6 points in the middle of the board (adhesive coverage should be at least 40%), and pressed onto a firm, clean substrate. On the glued thermal insulation boards, after 2-3 days, we recommend dowelling (6 pcs/m²). The reinforcing mesh is installed by pressing it into the previously applied layer of STIROMOL Thermo, in a thickness of 2-3mm, with a 10cm overlap, after which the entire surface is smoothed with STIROMOL Thermo adhesive. The total thickness of the applied STIROMOL Thermo layer should be at least 4mm.
Working temperature: The optimal working temperature is from +10°C to +30°C. It must not be used below +5°C, or in strong sun, wind, fog and rain. Under optimal conditions, freshly applied surfaces should be protected from atmospheric influences for at least 24 hours.
Consumption: From 3.5-5kg/m² for gluing and 4-5kg/m² for reinforcing.
Shelf life and storage: 12 months from the production date indicated on the packaging. Store in closed and undamaged packaging, in a dry and ventilated room.